![]() ![]() This product is certified to the Standard for Non-industrial Photoelectric Switches for Lighting Control UL773A and applicable Canadian Standards. If you don’t know which wire is hot and load wire, turn on the power and use the non-contact voltage tester to confirm. Tie and connect all neutral wires together. Connect the load wire to your light to the load wire on the motion sensor. Additional swivel is also available for further adjustment. Connect the wires: Connect the hot wire from your house to the hot wire on the motion sensor. It has a gathered swivel with the sensor/switch body for convenient direction adjustment after installation. A temperature compensator system provides consistent performance regardless of the ambient temperature. If so, refer to the manufacturer’s instructions to be sure which wire is the live wire. ![]() This product is designed on the basis of electrical heating structure that provides time delay over 30 seconds to avoid redundant switching against spotlight or lightning during the night time. The first step to installing your outdoor security lights is to shut off the power at the service panel and remove the existing floodlight. The photoelectric switch is applicable to control the Outdoor Lighting, Passage Lighting and Doorway Lighting automatically in accordance with the ambient lighting level. This will cause the unit to cycle on and off at night. Wire according to the diagram in right hand.ĭo not install the switch with the Photocell Switch facing artificial or reflected light. Disconnect power, remove junction box cover, place the SWITCH in knockout hole and fasten with lock nut.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |